Description
ACM V1 Strike Steel Half Face Mask (Two Belt Version – Black)
The ACM V1 Strike Steel Half Face Mask is a steel mesh mask that covers the lower face, protecting your mouth, teeth, nose and cheeks from BB hits. This is the two-belt version in black, held on by two straps that run around the back of the head.
Mesh lower-face masks are among the most popular forms of face protection in airsoft because they are light, tough, breathable and inexpensive. Black goes with almost any loadout, from all-black CQB kit to woodland camouflage, and it keeps the mask low-key on your face.
Protection and breathing
A BB in the teeth or lips is painful and can cause real damage, which is why lower-face protection is a good idea at any site and is often required for younger players or in close-quarters games. Steel mesh stops BBs while letting air pass freely, so you can breathe and call to your team easily.
Because warm breath escapes through the mesh rather than being pushed up into your goggles, a mesh mask also helps keep fogging under control on cold or damp days.
Two-belt fit
Using two straps spreads the hold across the back of the head, so the mask stays in place when you run, crouch or go prone. Adjust both straps until the mask sits snugly without pressing on your nose, and make sure the top edge meets your goggles without a gap.
If you wear a helmet, cap or headset, try the straps with it before game day so the buckles sit comfortably.
Key features
- Steel mesh lower-face protection
- Two-belt (double strap) version for a secure fit
- Covers mouth, nose, cheeks and jaw
- Breathable, so you can talk and breathe easily
- Helps reduce goggle fogging
- Black finish that suits any loadout
- Light and inexpensive
Compatibility
This mask protects the lower face only, so wear it with sealed, impact-rated airsoft goggles or glasses. Check that your goggles sit comfortably on the top edge of the mask. Two-strap masks fit under most caps and helmets, but try it with your own kit. The same mask is also available in other colours if you want to match a particular loadout.
Care and maintenance
Rinse off mud and sweat with warm water and a little mild soap, then let the mask dry fully before storing it so the steel and fittings do not corrode. Check the mesh for dents or broken strands after heavy hits, and replace the mask if it is damaged.
Store it where it will not be crushed, as a bent mask will not sit properly on your face.
Who is it for?
Players who want simple, breathable lower-face protection with a secure two-strap fit, in a black finish that works with almost any kit.
Please note: This mask protects the lower face only. Always wear suitable, impact-rated eye protection as well.
